High-efficiency, high-count-rate 2D superconducting nanowire single-photon detector array (2501.07357v1)

Abstract: Superconducting nanowire single-photon detectors (SNSPDs) are the current leading technology for the detection of single-photons in the near-infrared (NIR) and short-wave infrared (SWIR) spectral regions, due to record performance in terms of detection efficiency, low dark count rate, minimal timing jitter, and high maximum count rates. The various geometry and design parameters of SNSPDs are often carefully tailored to specific applications, resulting in challenges in optimising each performance characteristic without adversely impacting others. In particular, when scaling to larger array formats, the key challenge is to manage the heat load generated by the many readout cables in the cryogenic cooling system. Here we demonstrate a practical, self-contained 64-pixel SNSPD array system which exhibits high performance of all operational parameters, for use in the strategically important SWIR spectral region. The detector is an 8x8 array of 27.5 x 27.8 {\mu}m pixels on a 30 {\mu}m pitch, which leads to an 80 -- 85% fill factor. At a wavelength of 1550nm, a uniform average per-pixel photon detection efficiency of 77.7% was measured and the observed system detection efficiency (SDE) across the entire array was 65%. A full performance characterisation is presented, including a dark count rate of 20 cps per pixel, full-width-half-maximum (FWHM) jitter of 100 ps per pixel, a 3-dB maximum count rate of 645 Mcps and no evidence of crosstalk at the 0.1% level. This camera system therefore facilitates a variety of picosecond time-resolved measurement-based applications that include biomedical imaging, quantum communications, and long-range single-photon light detection and ranging (LiDAR) and 3D imaging.