Fault reactivation by fluid injection: Controls from stress state and injection rate

Abstract: We studied the influence of stress state and fluid injection rate on the reactivation of faults. We conducted experiments on a saw-cut Westerly granite sample under triaxial stress conditions. Fault reactivation was triggered by injecting fluids through a borehole directly connected to the fault. Our results show that the peak fluid pressure at the borehole leading to reactivation depends on injection rate. The higher the injection rate, the higher the peak fluid pressure allowing fault reactivation. Elastic wave velocity measurements along fault strike highlight that high injection rates induce significant fluid pressure heterogeneities, which explains that the onset of fault reactivation is not determined by a conventional Coulomb law and effective stress principle, but rather by a nonlocal rupture initiation criterion. Our results demonstrate that increasing the injection rate enhances the transition from drained to undrained conditions, where local but intense fluid pressures perturbations can reactivate large faults.