FliPer: A global measure of power density to estimate surface gravities of main-sequence Solar-like stars and red giants (1809.05105v1)

Abstract: Asteroseismology provides global stellar parameters such as masses, radii or surface gravities using the mean global seismic parameters as well as the effective temperature for thousands of low-mass stars $(0.8 M_\odot <M<3 M_\odot)$. This methodology has been successfully applied to stars in which acoustic modes excited by turbulent convection are measured. Other techniques such as the Flicker can also be used to determine stellar surface gravities, but only works for $\log{g}$ above $2.5$ dex. In this work, we present a new metric called FliPer (the acronym stands for Flicker in spectral power density, in opposition to the standard Flicker measurement which is computed in the time domain that is able to extend the range for which reliable surface gravities can be obtained ($0.1<\log{g}<4.6$ dex) without performing any seismic analysis for stars brighter than $\textit{Kp}$ $<$ 14. FliPer takes into account the average variability of a star measured in the power density spectrum in a given range of frequencies. However, FliPer values calculated on several ranges of frequency are required to better characterize a star. Using a large set of asteroseismic targets it is possible to calibrate the behavior of surface gravity with FliPer through machine learning. This calibration made with a random forest regressor covers a wide range of surface gravities from main-sequence stars to subgiants and red giants, with very small uncertainties from $0.04$ to $0.1$ dex. FliPer values can be inserted in automatic global seismic pipelines to either give an estimation of the stellar surface gravity or to assess the quality of the seismic results by detecting any outliers in the obtained $\nu_{max}$ values. FliPer also constrain the surface gravities of main-sequence dwarfs using only long cadence data for which the Nyquist frequency is too low to measure the acoustic-mode properties.