2000 character limit reached
Modelling, identification and geometric control of autonomous quadcopters for agile maneuvering (2306.09651v1)
Published 16 Jun 2023 in cs.RO, cs.SY, and eess.SY
Abstract: This paper presents a multi-step procedure to construct the dynamic motion model of an autonomous quadcopter, identify the model parameters, and design a model-based nonlinear trajectory tracking controller. The aim of the proposed method is to speed up the commissioning of a new quadcopter design, i.e., to enable the drone to perform agile maneuvers with high precision in the shortest time possible. After a brief introduction to the theoretical background of the modelling and control design, the steps of the proposed method are presented using the example of a self-developed quadcopter platform. The performance of the method is tested and evaluated by real flight experiments.
- L. M. Argentim, W. C. Rezende, P. E. Santos, and R. A. Aguiar, “PID, LQR and LQR-PID on a quadcopter platform,” in Proc. of the International Conference on Informatics, Electronics and Vision, pp. 1–6, 2013.
- T. Lee, M. Leok, and N. H. McClamroch, “Geometric tracking control of a quadrotor UAV on SE(3),” in Proc. of the 49th IEEE Conference on Decision and Control, pp. 5420–5425, 2010.
- P. Antal, T. Péni, and R. Tóth, “Nonlinear control method for backflipping with miniature quadcopters,” IFAC-PapersOnLine, vol. 55, no. 14, pp. 133–138, 2022. 11th IFAC Symposium on Intelligent Autonomous Vehicles.
- P. Antal, T. Péni, and R. Tóth, “Backflipping with miniature quadcopters by Gaussian Process based control and planning.” arXiv: 2209.14652, 2022.
- R. Mahony, V. Kumar, and P. Corke, “Multirotor Aerial Vehicles: Modeling, Estimation, and Control of Quadrotor,” IEEE Robotics & Automation Magazine, vol. 19, no. 3, pp. 20–32, 2012.
- M. Bisheban, Geometric Control of a Quadrotor Unmanned Aerial Vehicle in Wind Fields. PhD thesis, George Washington University, 2019.
- D. Lee and S. Sastry, “Feedback linearization vs. adaptive sliding mode control for a quadrotor helicopter,” International Journal of Control, Automation and Systems, vol. 7, pp. 419–428, 06 2009.
- M. J. Van Nieuwstadt and R. M. Murray, “Real Time Trajectory Generation for Differentially Flat Systems,” International Journal of Robust and Nonlinear Control, vol. 8, no. 11, pp. 995–1020, 1998.
- D. Mellinger and V. Kumar, “Minimum snap trajectory generation and control for quadrotors,” in Proc. of the IEEE International Conference on Robotics and Automation, pp. 2520–2525, 2011.
- J. Förster, “System identification of the Crazyflie 2.0 nano quadrocopter,” Bachelor’s Thesis, ETH Zurich, Zurich, 2015.
- Z. Mustapa, S. Saat, S. H. Husin, and T. Zaid, “Quadcopter physical parameter identification and altitude system analysis,” in 2014 IEEE Symposium on Industrial Electronics and Applications (ISIEA), pp. 130–135, 2014.